5
XL-AS11406OM-en-US Rev E · 2018-04-17 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Decal Requirements
2. Standard Decal Requirements
The following three (3) decals MUST be properly installed on
the trailer prior to putting it in service:
Tire Clearance Warning Decal: XL-AR356-01
(Figure 1)
.
SwingAlign Axle Alignment Decal: XL-AR435
(Figure 2)
.
Torque Decal: XL-AR436
(Figure 3)
.
Shear Bolt Decal: XL-AS20085DC-en-US
(Figure 4)
.
Figure 1
WARNING
Minimum tire clearance
MUST
be maintained between tires and
nearest point of contact on the suspension or vehicle. Premature
tire wear, fire or loss of vehicle control could result from contact
with the tires if clearances are not maintained.
XL-AR356-01
TIRE CLEARANCE REQUIREMENTS
•
1 INCH (25.4 mm) MINIMUM VERTICAL
tire clearance is required between the top of the tire
and the nearest point of contact above the tire when the air pressure is completely exhausted
from the air suspension or when the axle is fully lifted if equipped with a suspension lift feature.
•
2 INCH (50.8 mm) MINIMUM LATERAL
tire clearance is required between the sides of the
tire and the nearest point of contact through total travel of the air suspension. This includes
when the wheels are fully turned in either direction if equipped with an SAF Self Steer Axle.
www.safholland.us
Copyright © 2011 • SAF-HOLLAND, Inc.
Figure 2
ALIGNMENT BOLT IS ON THE FRONT OF THE ROADSIDE FRAME BRACKET:
XL-AR435 Rev. B
STEP 1.
To properly align the suspension, the trailer should be pulled in a straight line for a sufficient distance
to insure there are no binds in the suspension.
STEP 2.
Check to verify trailer is empty and emergency brakes are
NOT
engaged.
STEP 3.
Rotate bolt
CLOCKWISE
to move axle forward (A arrows);
COUNTERCLOCKWISE
to move axle rearward (B arrows).
A = axle forward
B = axle rearward
ALIGNMENT BOLT HEAD
NOTE:
1/2 turn of
free play in either
direction (A or B)
is acceptable.
SWING ALIGN
®
NON-WELDED AXLE ALIGNMENT PROCEDURES
www.safholland.us
Copyright © 2011 • SAF-HOLLAND, Inc.
Figure 4
It is the responsibility of the end user to periodically inspect
all decals and ensure that they are clean and completely legible.
If any decals are missing, loose, damaged or difficult to read,
contact SAF-HOLLAND Customer Service at 888-396-6501
to order replacements immediately.
Figure 3
Summary of Contents for CB-14
Page 2: ......
