17
XL-AS11406OM-en-US Rev E · 2018-04-17 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Torque Specifications
17. Torque Specifications
Figure 24
COMPONENT
TORQUE VALUE
FASTENER
SIZE
Shock Absorber
140-175 ft.-lbs.
190-237 N•m
3/4"
Pivot Connection, Hex Head Bolt
550-600 ft.-lbs.
746-813 N•m
1-1/8"
* Pivot Connection,
Pan Head Shear Bolt
Visual Inspection
7/8"
Lower Air Spring Nut
30-40 ft.-lbs.
40-54 N•m
1/2"
Upper Air Spring Nut
40-45 ft.-lbs.
54-61 N•m
3/4"
SwingAlign Mounting Fasteners
Only - NOT Pivot Bolt
50-60 ft.-lbs.
68-81 N•m
1/2"
Height Control Valve Lower Linkage
30-40 In.-lbs.
3-5 N•m
1/4"
Table 3
NOTE:
Torque specifications listed above are with
clean lubricated / coated threads
(
Table 3)
.
All new SAF-HOLLAND fasteners come precoated
from the factory. For bolt and lock nut grade
markings refer to
Figure 24
.
IMPORTANT:
The use of special lubricants with friction
modifiers, such as Anti-Seize or Never-Seez
®
,
without written approval from SAF-HOLLAND
engineering, will void warranty and could
lead to over torquing of fasteners or other
component issues.
General Information
1. The torque specifications are applied to the nut and NOT
the bolt.
Failure to use the proper fasteners when
servicing the suspension could cause
component failure which, if not avoided,
could result in death or serious injury.
Failure to properly torque all fasteners
could result in component failure which,
if not avoided, could result in death or
serious injury.
All torque specifications are ± 5%.
Torques specified are for clean, lubricated threads.
Always Apply torque to nut if possible.
Required re-torquing at every brake re-lining.
* If equipped with 7/8" pan head shear bolt, ensure that the spline is
sheared off and that there are no signs of movement.
BOLT IDENTIFICATION
LOCK NUT IDENTIFICATION
6 DOTS
3 DOTS
LOCK NUT
GRADE C
LOCK NUT
GRADE B
GRADE 5
GRADE 8
7/8" PAN HEAD
SHEAR BOLT
Summary of Contents for CB-14
Page 2: ......
