Please keep the RPM according to below diagram against the accident.
(The allowable RPM could be
different depending on the bur
material and type).
10. Bur
-
Bur dimension: 2.35 mm (ISO7785-2
TYPE2).
-
Minimum fitting lenght of bur: 10 mm.
-
When locked chuck, the maximum
projection lenght of bur should be at least
35 mm.
-
Use the bur ISO standard and avoid using a
rusty and bent bur causing excessive wear
of bearings.
Keep safe speed and precautions
recommended by bur manufacturer.
11. Be careful not to drop the handpiece as it
may be damaged or broken. In case that it
is dropped, check if the bur is bent or
excessive heat is generated while
operating.
12. If any problem occurs in handpiece, use
after repairing.
13. Make sure that the switch is off before
putting the power plug in the socket, in
order to avoid an unexpected injury caused
due to sudden start.
14. A circuit breaker is provided to protect the
motor. It is actuated when there is an
overload switch the motor cannot stand.
Work withing a range of load which it is not
actuated.
15. Do not open the chuck while operating.
16. Keep the handpiece with setting a bur to
the collet chuck after operation.
17. Do not put the handpiece down before it
stops completely.
18. Be sure to pull out the power cord before
detaching the control box.
19. Use the specified voltage.
20. Use accessories suitable for this product.
21. For recommended speeds in various
applications, follow the manufacturer
instructions.
22. Wear proper protective clothes and
equipment, including a dust mask and
safety goggles. Use a proper suction unit
and a ventilator.
23. Keep the workplace clean. Debris may
cause an accident.
