Launch
user's guidance
1
、
PCB quick-diagnosis software has certain requirements for running computer
configuration. It is recommended to use processor I3 and above, memory.
Computers with 2G and above can operate normally.
2
、
The computer and PCB quick-access device can be connected by USB to the RJ45
network interface. The software may not be recognized automatically.
There is no image phenomenon when adding the IP address of the PCB quick-up
device. You need to manually set the IP address of the computer to use it normally.
For details, see "Product Q & A 1"
FAQ
1. What is the delay in the software image?
A: The software has certain requirements for the computer configuration. It is necessary to configure the
processor I3 or above and the memory above 2G to run normally. If the computer configuration is low,
the delay will occur.
2. What if the software does not have an image?
A: First check whether the device is powered on properly and the network cable is connected. If the two
are normal, check whether the firmware version number in the System Configuration > About menu is
displayed. If there is no display, the device IP address fails to be added. Cause, you need to manually
configure the computer IP address, the specific operation is as follows:
Windows 7 operating system computer settings: Click on the network in the lower right corner of the
computer Click "Open Network and Sharing Center" Click "Change Network Adapter Settings" Double-
click "Local Area Connection" or click
Right click on the right button in the pop up menu bar and double click on "Internet Protocol Version"
(TCP/IPV4)
”
Click
“
Advanced
”
IP address (R) and click
“
Add
”
as follows IP address: 192.168.2.99
Sub net mask: 255.255.255.0
Click "Add" and always click "Confirm" as prompted until the setting is completed.
Windows 10 Operating Computer System Computer Settings: Click on the network in the lower right
corner of the computer Click on "Network Settings"
