Saeco Minuto, Service Manual

Page: 24 / 109

MINUTO 03 USER INSTRUCTIONS
Page / 13
The machine is heating-up to brew beverages or dispense hot water.
The machine is in warm-up phase to brew beverages or dispense hot water/steam.
Class
Focus
The machine is performing the
rinse phase. Wait until the machine
has completed the cycle.
The brew group is being reset
due to machine reset.
The machine needs the
“” water fi lter to be
replaced.
Machine ready signals ( YELLOW colour )
Re fi ll the coffee bean hopper
with coffee beans.
Put back the coffee bean
hopper lid and restart the cycle.
Prime the circuit.
The machine needs to be descaled. Press the “ ” button to enter the
descaling menu.
If you want to descale later, press the “ ” button to continue using the
machine.
Please note that not descaling your machine will ultimately make it stop working
properly. In this case repair is NOT covered under your warranty
Completely insert the drip tray
with the coff ee grounds drawer
into the machine and close the
service door.
Turn off the machine. After 30 seconds, turn it on again. Try this 2 or 3 times.
If the machine does not start, contact the Philips SAECO hotline in your country and
communicate the the Error-code which you see on the display.
You can fi nd its contact details in the warranty booklet by-packed separately
or on www.philips.com/support.
The brew group must be inserted
into the machine.
Empty the coff ee grounds
drawer. Wait about 5 seconds
before placing it back.
Fill the water tank. Fill the coffee bean hopper.
Machine ready signals ( RED colour )
Exx
08
Set the “ESPRESSO” or “COFFEE” selection lever to “ESPRESSO” within 30
seconds to complete brewing.
Set the “ESPRESSO” or “COFFEE” selection lever to “COFFEE” within 30 seconds
to complete brewing.
A beverage has been selected without the coffee bean hopper inner lid on the
machine. Place the coffee bean hopper lid on the machine within 30 seconds to
complete brewing.