Saeco Incanto HD8917, Manual

Page: 36 / 80

The filter has not been replaced in
time after the AquaClean water filter
signal started flashing.
Descale your machine first and
install the filter.
The filter has not been installed
during first installation but after
having brewed approx.50 coffees
(based on 100ml cups). The machine
has to be completely limescale-free
before installing the AquaClean filter.
First descale the machine and
then install a new AquaClean filter.
After descaling, the filter counter is
reset to 0/8. Always confirm filter
activation in the machine menu,
also after filter replacement
The AquaClean filter was not
correctly activated during first
installation.
Follow the instructions on the
display until you receive
confirmation that the filter has
been activated.
The AquaClean filter is
installed, but the
descaling message
appears.
After 8 filter replacements, you need
to descale the machine
First descale the machine and
then install a new AquaClean filter.
This will reset the filter counter to
0/8. Always confirm filter
activation in the machine menu,
also after filter replacement.
The descaling message
appears before 8 filters
were replaced.
You did not activate the AquaClean
filter correctly during first installation.
First descale the machine and
then install a new AquaClean filter.
Always activate the filter in the
machine menu.
You placed the AquaClean filter after
having used the machine for a while.
You did not activate the replacement
filter in the machine menu.
You did not replace the filter when
the filter symbol started flashing.
The filter does not fit. You need to remove air from the
filter.
Let air bubbles come out of the
filter.
There is still water in the water tank. Empty the water tank before you
install the filter.
You try to install another filter than
the AquaClean filter.
Only the AquaClean filter will fit.
There is water under the
machine.
The drip tray is too full and
overflowed.
Empty the drip tray when the drip
tray full indicator pops up through
the drip tray. Always empty the
drip tray before you start descaling
the machine.
The machine is not placed on a
horizontal surface.
Place the machine on a horizontal
surface so that the drop iray full
indicator works properly.
Note: If you are unable to solve the problem with the information in this
table, contact the Saeco Consumer Care Centre.
35
English