7
1
4
5
3
2
IntenZa Water fIlter
To improve the quality of the water you use and extend the life of your machine at the same time, it is recommended that you install the
water fi lter. After installation, go to the water fi lter initialization programme (see the "MACHINE MENU", page 27). In this way, the machine
informs the user when the water fi lter must be replaced.
Remove the water fi lter from its packaging, immerse it vertically (with the opening positioned upwards) in cold water and
gently press its sides to let the air bubbles out.
Remove the small white fi lter from the
tank and store it in a dry place sheltered
from dust.
Fill the tank with fresh drinking water
and re-insert it into the machine.
Place a container beneath the hot water/
steam wand.
Insert the fi lter in the empty tank. The
reference mark and the groove must
match. Push fi rmly until it is completely
inserted.
Set up the Intenza Aroma System:
A = Soft water
B = Medium water (standard)
C = Hard water
Press the "OK" button.
Press the "OK" button to confi rm the
introduction of the new water fi lter.
Press the "OK" button to confi rm. Wait
until the cycle is completed and remove
the container.
Access the "MACHINE MENU" (see page
27). Select "WATER SETTINGS" and
"ACTIVATE FILTER", then press "OK".
ESC
OK
WATER HARDNESS 3
ENABLE FILTER OFF
ACTIVATE FILTER
2.4. WATER SETTINGS
6
ESC
OK
ACTIVATE FILTER?
2.4.3. WATER SETTINGS
7
OK
OK
INSERT WATER FILTER
AND REFILL THE WATER TANK
8
OK
OK
PLACE A CONTAINER UNDER HOT
WATER & DISP. SPOUT
9
NOTE: At the end of the procedure the display automatically returns to the product dispensing page.
If the Intenza water fi lter is not available, insert the small white fi lter previously removed (see point 1) into the tank.
