Saeco HD8914, Owner'S Manual

Page: 25 / 76

3 Put a degreasing tablet in the pre-ground coffee compartment.
4
Press the ESPRESSO LUNGO button. The machine dispenses water from
the coffee dispensing spout.
5 When the progress bar has reached the middle, set the main switch on
the back of the machine to OFF.
6 Let the degreasing solution work for approximately 15 minutes.
7
Set the main switch to ON.
8 Press the standby button.
9 Wait until the machine performs an automatic rinsing cycle.
10
Perform the 'Weekly cleaning of the brew group' procedure.
11
Remove the drip tray with the coffee grounds container. Empty the drip
tray and the coffee grounds container and place them back into the
machine.
12
Press the AROMA STRENGTH button and select pre-ground coffee.
13
Press the ESPRESSO LUNGO button. The machine dispenses water from
the coffee dispensing spout.
14 Repeat steps 12 and 13 twice. Discard the dispensed water.
15
To clean the drip tray, put a degreasing tablet in the drip tray and fill the
drip tray up to two-thirds of its capacity with hot water. Let the
degreasing tablet take effect for about 30 minutes. Then empty the drip
tray and rinse it thoroughly.
Lubrication of the brew group
For optimal performance of the machine you have to lubricate the brew
group. See table below for the lubrication frequency. For support visit our
website: www.philips.com/support.
Type of usage Nr of daily products Lubrication frequency
Low 1-5 Every 4 months
Normal 6-10 Every 2 months
Heavy >10 Monthly
1
Switch off the machine and unplug it.
2
Remove the brew group and rinse it under a lukewarm tap as described
in section 'Weekly cleaning of the brew group'.
3 Apply a thin layer of grease around the shaft in the bottom of the brew
group.
25
English