• 26 •
1-
To prepare a cappuccino, insert an espresso capsule (black) as
described in the section “Brewing coffee”.
2-
Insert the carafe into the machine and ensure that the milk is
above the MIN level.
3-
Adjust the machine to fit the cup into which your cappuc-
cino will be dispensed (see section “Adjusting the dispensing
height”).
4-
Insert a cup below the coffee and milk
dispensing spouts.
5-
Press the cappuccino button
.
6-
The cappuccino button
flashes;
the machine is warming up.
7-
When it has finished warming up, the
machine dispenses the frothed milk
directly into the cup. The machine will
stop dispensing when it reaches the
preset quantity. The dispensing process can be stopped early by
pressing the cappuccino button
.
8-
When it has finished dispensing the milk, the machine auto-
matically dispenses the espresso coffee directly into the cup. The
dispensing process can be stopped early by pressing the cappuc-
cino button
.
When the cappuccino has finished brewing, the rinse
button
will light up to remind you that the milk
circuit must be rinsed; see section “Rinsing the milk circuit”
in this chapter.
Adjusting the amount of cappuccino
The machine allows you to adjust the amount of cappuccino brewed
according to your taste and the size of your cup.
Before preparing a cappuccino, check that the On/Off
button and beverage buttons are constantly lit
and that there is enough water in the tank.
Proceed as follows to set the desired quantity of cappuccino
:
1-
Insert an espresso capsule into the capsule compartment.
2-
Insert the carafe into the machine and ensure that the milk is
above the MIN level.
3-
Press and hold the cappuccino button
for 3 seconds until it
flashes in brief intervals. Then release the button.
4-
Press the cappuccino button
again when the amount of
milk in the cup reaches the desired level. The machine has saved
the desired amount of milk and will start to brew the espresso.
5-
Press the cappuccino button
again when the amount of
coffee in the cup reaches the desired level. The machine has
saved the desired amount of espresso.
At this point the cappuccino button
has been reprogrammed;
each time it is pressed, the machine will dispense the same amount
of milk and espresso that was just programmed.
Minimum quantity of espresso that can be set: approx. 30 ml
Maximum quantity of espresso that can be set: approx. 300 ml
Minimum quantity of milk that can be set: approx. 50 ml
Maximum quantity of milk that can be set: approx. 300 ml
Preset quantities:
Cappuccino approx. 90 ml milk
approx. 40 ml espresso
Restoring the preset quantities
To reset beverages to their factory settings, with the machine off,
press and hold the On/Off and filter coffee
(blue) buttons
for 5 seconds. All buttons will flash twice in confirmation.
Frothed milk
Before preparing frothed milk, check that the On/Off
button and beverage buttons are constantly lit
and that there is enough water in the tank.
Remember, it is not necessary to insert a coffee
capsule in order to prepare frothed milk.
1-
Insert the carafe into the machine and ensure that the milk is
above the MIN level.
2-
Adjust the machine to fit the glass
into which your frothed milk will be
dispensed (see section “Adjusting the
dispensing height“).
3-
Place a glass under the milk dispensing
spout.
4-
DO NOT insert a coffee capsule into the
capsule compartment.
5-
Press the frothed milk button .
6-
The frothed milk button flashes; the machine is warming up.
7-
When it has finished warming up, the machine dispenses the
frothed milk directly into the glass. The machine will stop
dispensing when it reaches the preset quantity. The dispens-
ing process can be stopped early by pressing the frothed milk
button .
When the machine has finished preparing the frothed
milk, the rinse button will light up to remind you
that the milk circuit must be rinsed; see section “Rinsing the
milk circuit“ in this chapter.
Adjusting the amount of frothed milk
The machine allows you to adjust the amount of frothed milk
prepared according to your preference and the size of your glass.
Before preparing the frothed milk, check that the
On/Off button and beverage buttons are con-
stantly lit and that there is enough water in the tank.
4219_404_3749_2_148X210_BW_V8.indd 26
13/11/15 12:42
