Saeco 5P, Instruction And Maintenance Manual

Page: 41 / 64

9
English
6.3 Electrical connection
The vending machine is pre-set for electrical operation with a sin-
gle-phase voltage whose value is stated in the identification tag
(Refer to “2.4 Vending machine identification”) (fig. 2).
Danger
The connection point of the electric outlet must be located in a
place that can be easily reached by the user, so that he can
easily disconnect the vending machine from the power supply
when required.
Before connecting, make sure that:
• The mains supply voltage of the outlet the vending machine is
connected to corresponds to the one indicated on the tag.
• The electric installation of the place where the vending ma-
chine is going to be installed complies with the laws in force,
and has the characteristics enabling it to stand the required
maximum load indicated on the tag.
Check the electric installation’s compliance with the safety rules in
force; in case of doubt, require an accurate electric installation
survey by qualified professional staff.
Danger
The use of adapters or patch cords is forbidden.
fig. 10
fig. 12
fig. 13
✕
fig. 11
6.4 Fitting the
PARALLEL 12 V d.c. coiner
Only 12 V d.c. parallel or mechanical coiners may be used on
this vending machine.
- Remove the token accepting device support (fig. 11).
- Drill a hole on the keypad panel (fig. 11).
- Insert the coiner and fix it by using the 4 supplied screws with
nuts (fig. 12).
- Connect the flat cable to the coiner (fig. 12).
- Connect the flat cable to the electronic board (fig. 13).
Important
The Company disclaims all responsibilities for damages to
vending machine, properties and people arising out of im-
proper installation of the payment system; this responsibility
falls directly on whoever performed the fitting.