Sacmi CCM001, User Manual

Page: 59 / 164

002AZ001A
4 - 1
INSTALLATION
4
4 INSTALLATION
4.1 SHIPPING AND HANDLING
MACHINE DIVISION
The machine is divided into groups depending on the shipping and installation requirements.
DIMENSION AND WEIGHTS
The weights and dimensions of the individual parts, in relation to the shipping requirements, are approximate therefore
they are given for reference purposes only.
SYSTEMS FOR LIFTING INDIVIDUAL PARTS
The best systems for lifting and handling the heaviest and largest parts as well as those that require special care and
tools provided by Sacmi are shown in the figure.
When lifting the smaller parts and packages, be careful and use the most suitable equipment observing the safety
precautions.
When the crates arrive on site, they must be handled with care and transported both inside and out, with means that
can support the weight of the crate.
It is fundamental that the user weighs all the parts when they arrive to verify their exact weight.
E0004P
WARNING!
The manufacturer shall not be held responsible for any property damage or personal injury resulting from failure
to observe current safety precautions regarding lifting and handling materials inside the factory.
PRECAUTIONS TO BE OBSERVED WHEN LIFTING PARTS
- Use lift equipment that has an adequate range of action and lift capacity suitable for the dimensions and weight to
be sustained. Place the equipment as shown in figure 4.1.
- Protect the points where the slings come into contact with the machine with cardboard or rags.
- Gradually move the crane until the load is perfectly stable.
- Slowly lift and move the load using extreme caution, avoid swaying it to even the slightest degree.
E0004P
WARNING!
The parts must be lifted and handled only by authorized persons who are specialized in carrying out this type of
operation.
It is vital that no persons are near the hanging load and/or within the range of action of the lift equipment while the
machine is being hoisted and moved.
- Follow the instructions for lifting the parts given in chapter 3, SAFETY EQUIPMENT AND PRECAUTIONS.
- The load must remain perfectly level while it is being moved regardless of the lift equipment employed.