General Notices
UK Declaration of Conformity
Videndum Production Solutions Ltd. declares under our sole responsibility that the product
detailed in this manual conforms with all relevant provisions of the following UK Regulations:
• The Electrical Equipment (Safety) Regulations 2016
• The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012
A copy of the declaration is available on request.
UK contact: Videndum Production Solutions Ltd, William Vinten Building, Easlea Road, Bury
St. Edmunds, IP32 7BY
EU Declaration of Conformity
Videndum Production Solutions Ltd. declares under our sole responsibility, suppor-
ted by Videndum Production Solutions GmbH - our authorized representative, that
the product detailed in this manual conforms with all relevant provisions of the
following EU directives:
• Restriction of Hazardous Substances Directive 2011/65/EU
• Electromagnetic Compatibility Directive 2014/30/EU
Low Voltage Directive 2014/35/EU
Radio Equipment Directive 2014/53/EU
A copy of the declaration is available on request. EU contact: Videndum Produc-
tion Solutions GmbH, Parkring 29, 85748 Garching, Germany
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
Modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment under
FCC rules.
General Notices
22
Summary of Contents for Cine 50
Page 1: ...Cine 50 S2019 4980 0 Publication date 02 02 24...
Page 24: ...24...
