V0.2 | 11.11.2019 14:46
5/8
weight with cable
1.76 oz (58 g)
What is the B100R?
The B100R is an control unit with integrated LCD display on
the handlebar. Since all important information is displayed on
the high-contrast 1.4-inch monochrome LCD, a larger display
in the centre of the handlebar is not required - the B100R is a
stand-alone system.
Mounting the B100R
Figure 1: B100R mounted on handlebar
The B100R is mounted on the left side of the handlebar of
your pedelec [Figure 1]. The entire surface of the LCD display
serves as a rocker switch for the "+" and "-" settings.
Additionally, the control unit has three buttons; two on the
side and one on the top. The switch and buttons allow you to
change the settings on your pedelec, e. g. the degree of
motor assistance, at any time without taking your hands off
the handlebars.
When mounting the B100R, observe the following [Figure 2]:
Figure 2: Correct torque, avoid pressure on the housing
Torque: The B100R is fixed with a 2.5 mm hexagon socket
head screw. Please do not tighten the screw with more than
1 N m (Newtonmeter) torque.
Caution: Make sure that nothing on the handlebar such as the
handle or brake lever presses against the side or underside of
the B100R (yellow arrow). This could affect the function of the
rocker switch.
Figure 3: Best viewing angle
The display is designed with an optimum viewing angle of
25 degrees below the vertical [Figure 3]. Loosen the fastening
screw and tilt the display on the handlebar until you have
found the optimum angle for your riding position. Then
retighten the screw with a torque of not more than 1 N m.
Notes on the connection of
the B100R connector
Figure 4: Female connector and male connector
If you need to open both ends of the plug on the cable
leading from the B100R to the pedelec frame, follow the
instructions below when reconnecting the plug.
The male connector on the cable comes from the B100R
[Figure 4, right], the female connector is at the other end of
the cable [Figure 4, left].
Figure 5: Align connector markings
Caution: The ends must be correctly aligned when connecting.
Coupling and plug are provided with a mark - align the
markings correctly [Figure 5].
