SAC 5000 Series, Operator'S Manual

Page: 19 / 72

Page 19
SPREADER OPERATION
',6&211(&77+,6(1'
&+$,1+$/9(672*(7+(5
5(029(%2/76
BEATER KICK-OUT OPTION
Some models have the beater “Kick-Out” option to allow for easier removal of obstructions in the spreader. If an
obstruction is encountered the following procedure must be followed.
1. DISABLE APRON DRIVE. DISENGAGE PTO. STOP ENGINE, AND REMOVE KEY FROM IGNITION!
2. Disconnect the PTO to the beaters from the output shaft at the rear of the spreader.
3. Chain the two halves of the PTO together using the chain provided and move PTO to ensure it is clear
of any driveline components.
4. Remove the four bolts holding the beater assembly to the spreader box.
5. Start engine.
6. Extend the beater assembly out. Insert cylinder stops on both kick-out cylinders.
(Cylinder stops are located on both sides of the beater assembly.)
7. STOP ENGINE, AND REMOVE KEY FROM IGNITION!
8. Carefully clear all obstructions.
9. When cleanout is complete ensure that all personnel are clear from the discharge area before restarting
the engine.
10. Restart engine and ensure that kick-out cylinders are fully extended.
11. Remove cylinder stops from both kick-out cylinders and return them to their storage position.
12. Lower the beater assembly.
13. STOP ENGINE, AND REMOVE IGNITION KEY.
14. Replace four bolts removed earlier from beater assembly.
15. Unchain the PTO and reconnect to the output shaft. Make sure that the PTO is locked in place
on the output shaft.
DANGER!
ALWAYS DISENGAGE PTO, STOP ENGINE AND REMOVE INGITION KEY
BEFORE SERVICING ANY COMPONENT ON THIS EQUIPMENT. FAILURE
TO FOLLOW THIS RULE CAN RESULT IN SERIOUS INJURY OR DEATH!
&</,1'(56723
6725('326,7,21
&</,1'(56723
$33/,('326,7,21