SAVE THESE INSTRUCTIONS
Sanding belt adjustment
Loosen the two nuts as shown in Fig. 10. (as
shown in the figure you can see only one nut,
another one is down below at the bottom of the
disc cover, follow the arrow instruction). After
you loosen the nuts, you can pull up the belt in
vertical position and tighten the nuts before
carry on your work
.
Exchanging of table position
When the belt is in vertical position, you can
move the table to-the front of the belt. First of
all, loosen the screw and move to the position
as in Fig. 11. Tighten the set
-
screw
but take
notice on the 3mm space left in between the
belt and the table.
Horizontal grinding
Put your work piece on the belt and assist with
the back stop to back up the work piece. When
start operation, beware the safety of your
hands. Do not push too hard on the work piece
for the belt works better without enforcement
of overdoing the job. Fig. 12.
Curve grinding
Use the very end of the belt to help your curve
grinding as shown in Fig. 13.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Operation
Summary of Contents for BDS6X9
Page 12: ...SAVE THESE INSTRUCTIONS ...
Page 13: ...Parts List ...
