2. Electronic Ignition Module.
NOTE: A licensed electrician should be used to install the ignition module.
This side burner has been supplied with enough wire to mount the ignition module up to 3 feet from the bottom of the side burner
as shown in Figure 1 below. The exact mounting location can vary based on the design of your enclosure. Mounting holes are
provided in the ignition module heat shield. Be sure to route all wires away from sharp edges that could cut or damage the
insulation. Also be sure to route the wire in a manner that will not allow them to come into contact with hot surfaces. NOTE: The
ignition module must be mounted so as to have easy access to the battery compartment for battery replacement. See Figure 2.
Connect wires to the small and large connections on the rear of the ignition module. See Figure 3.
INSTALLATION CON’T.
Rotate cap counterclockwise
to open battery compartment.
Figure 2
Figure 3
2 Large Connectors
1 Small
Connector
+
-
1. Separate EI module from heat shield.
2. Mount heat shield using 2 screw holes supplied.
3. Assembly EI module to heat shield using nut.
4. Install battery and cap.
5. Attached wires as shown.
Cap
Nut
EI Module
Heat Shield
Battery
Mounting holes
9
Ignition Module
& Heat Shield
Figure 1
3 ft
