Sabaj K-2, User Manual

Page: 9 / 18

9
It is possible to assign two selected buttons of any infrared remote control (TV, CABLE, DVD, etc.). Selected
buttons will be used to control the movement of the elevator up and down (UP, DOWN)
To assign an infrared remote control, do the following:
• Connect an infrared receiver to raise the control box back.
• Press and hold the SETUP button (blue) for about 3 seconds until you hear a beep and the red SETUP indicator
lights up. Now you are in setup mode.
• Select the button on the IR remote control that you would like to move up. Aim the remote control at the
infrared receiver and press the selected button. The red Power LED dims once confirming the reception of the
remote control signal
• Select the button on the IR remote control that you would like to use for the DOWN movement. Aim the
remote control at the infrared receiver and press the desired key. Red, the power LED will go off twice,
confirming the reception of the remote control signal
• Press and hold the SETUP button (blue) for about 3 seconds until you hear two beeps and the red SETUP
indicator goes off. Your infrared remote control has been registered.
Setting RF control
The supplied RF remote control is already programmed with your TV-Lift. If you are programming yourself, use
the following steps:

press and hold the RC SET button for approx. 3 sec.

the lift will wait for a signal from the remote control for 15 seconds.

press any button on the remote control

the lift will save the new remote control, which will now be active
NOTE: The controller has memory for 8 pilots. If you want to program the 9th remote control, it will be
overwritten for the 1st.
Active RJ-45 socket
Your driver in the Premium version is equipped with an active RJ-45 socket, which allows you to connect
additional accessories supplied by Sabaj-System. NOTE: Only the original accessories manufactured by Sabaj-
System will be compatible with your driver. If you attempt to modify or connect other devices via the RJ-45 port,
you may damage or destroy the controller - this will void the warranty.