Sabaj K-2, User Manual

Page: 8 / 18

CONTROL BOX MANUAL K-DOWN
The above image is of the lift Mechanism’s Control Unit’s keypad.
Programming the VP (Viewing Position)
ATTENTION! You have to set the VP it you want all of the lifts
functions to work properly
To set the VP follow this procedure:

Press&Hold the SETUP button for about 3 seconds, until you will hear two short “beeps” and the red
SETUP light is lit
You are now in the programming mode:

Press&Hold the UP or DOWN button to set the preferred position. You can change the movement
speed in the setup mode, by pressing the SETUP button once. There are 2 movement speeds.
ATTENTION! The safety system is turned off in the setup mode. The lift is moving slower than
normally
When you have set you preferred position, press&hold the SETUP button for about 3 seconds,
until you will hear two short “beeps” and the red SETUP light is down. The viewing position is
now set.
Remote Control assignment
To assign the remote control, press the SET button and then press any button and hold one of the
remotes buttons for about 1 second. If the remote is assigned, you will hear a short “beep”.
ATTENTION! the remote assignment mode is active for about 30 seconds after pressing&holding the
SET button. If the signal from the remote is not received during this time, the control box will quit the
remote assignment mode.
Display messages:
The numeric display shows the information about the lift operation. If the display shows :

“0” Blinking - electric motor overload (current exceeded)

“1” Blinking – inactive

“2” Blinking – inactive

“3” Blinking - wiring loom not connected to the control box

“4” Blinking - lower limit switch activated

“5” Blinking – upper limit switch activated

„h” Blinking - no motor impulses
Pressing any button will delete the display message.
IR remote control assignment (IR version only)
DOWN
U
UP
P
SETUP
CODE
RCSET
SETUP