K-ECO IR/RF
18
NOTE:
Only the original SABAJGROUP accessories will work with your control box. If you attempt
to modify or connect any other devices via the RJ-45 port, you might damage the control box and
you will loose the warranty for doing so.
15.
Engine overheat protection:
Lift is equipped with an electric motor safety system, that
prevents the motor from overheating by carrying a load that is heavier than possible. It does
not require any calibration, which is done automatically.
Lift operating - control
Every control box with RF function is delivered with a pre-progammed RF Remote. Only Sabaj
RF remotes can operate with Sabaj control boxes. The buttons on the RF remote control are pre-
programmed and cannot be changed.
The control box has 2 levels of setup.
SETUP mode
is acquired by pressing & holding the
SETUP button
, and is signalized by a
RED
SETUP LED light
.
Motion MEMORY mode
is acquired by pressing the
RC-SET button
. You will hear short beeping
sound.
16.
Programming a new RF remote (only in RF version):
The control box can store up to 8
different RF remotes. To program a new RF remote:
a. Press the
RC-SET button
. You will see this symbol on the digital display
b. Press & hold for about 2 seconds any button on the RF remote. Properly
programmed remote will result with the digital display symbol disappearing, and a
short beep.
NOTE:
Pressing and holding the RC-SET button for 5 seconds deletes all registered RF remotes.
17.
Programming a new IR remote (only for IR version):
The IR-Multicode system allows
you to use any infrared remote control of the most popular TV screen manufacturers. You
can program the remote control with which you control your TV. To start acquiring the IR
remote:
a. Press & hold
SETUP button
for about 2 seconds
–
red SETUP led
will be lit.
b. Press
RC-SET (Memory) button
once - you will hear constant short beep signals.
Then press
SETUP button
– beep signal will stop. You will see this symbol on the
display:
The control box is now awaiting IR signals.
up
down
fig. 11
