Saba SVD2630 Operating Instructions Manual Download Page 57

Page: 57 / 134

English

- 55 -

Connecting to a DVD Player via
HDMI

Please refer to your DVD player’s instruction book
for additional information. Power off both the TV and
the device before making any connections.
Note

: Not all cables shown in the illustration are

supplied.

If your DVD player has an

•

HDMI

socket, you can

connect via

HDMI

for better video and audio quality.

DMI

SPDIF

Coax.OUT

External device

(not

supplied)

HDMI Cable

When you connect to DVD player as illustrated above,

•

switch to the connected

HDMI

source. See,

Input

Selection

section for more information on changing

sources.

Connecting to a DVD Player via
Component Sockets (YPbPr) or
Scart Cable

Some DVD players are connected through

•

COMPONENT SOCKETS (YPbPr)

. In this case,

you must use the supplied Component video
connection cable for enabling connection. First,
plug single jack of the cable to the TV’s YPbPr
socket (side). Afterwards, insert your component
cable’s (not supplied) connectors into the plural
part of the Component video connection cable (see
illustration below). Colours of the connected jacks
should match.
To enable audio connection, use the

•

VGA/

Component Audio cable

. First, plug single jack

of the cable to the TV. Afterwards, insert your DVD
player’s audio cable’s connectors into the plural part
of the

VGA/Component audio connection cable

(

see illustration below

). Colours of the connected

jacks should match.

YPbPr

Side view

DVD Player

Connection Cable

(supplied)

YPbPr Video Cable

(Not supplied)

When the connection is made, switch to

•

YPbPr

source. See,

Input selection

section.

Note:

To connect Y Pb Pr device, you should use

supplied component (YPbPr) connection cable

You may also connect through the

•

SCART

input.

Multipartition HDDs are supported until two

•

partitions.
Some stream packets may not be recorded because

•

of signal problems, so sometimes video may freezes
during playback.
Record, Play, Pause, Display (for PlayListDialog)

•

keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.

Connecting the LCD TV to a PC

For displaying your computer’s screen image on your
LCD TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use 15-pin D-sub display cable to
connect a PC to the LCD TV. When the connection
is made, switch to PC source. See “Input selection”
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts.

PC audio cable

(not supplied)

PC VGA cable
(not supplied)

Audio inputs of the TV

PC input of the TV

Audio output of the PC

Monitor output of the PC

Using Side AV Connectors

You can connect a range of optional equipment to
your LCD TV..

For connecting a camcorder, connect to the VIDEO

•

IN socket and the AUDIO SOCKETS. Do not connect
the camcoder to VIDEO IN socket at the same time
since it can cause noise in the picture. For selecting
the related source, see the section “Input selection”
in the following parts.
To listen the TV sound from headphones, connect

•

to the HEADPHONE jack of theTV.

02_[GB]_MB60_(01-TV)_1900UK_PVR_ypbpr_26884W_BRONZE17_10072935_50189090.indd 55

01.06.2011 11:49:07