WARNING
• Do not over tighten the filters� Put the filters back in sequence
securely, otherwise coarse debris could get into the system
and cause a blockage�
• Never use the dishwasher without filters in place� Improper
replacement of the filter may reduce the performance level of
the appliance and damage dishes and utensils�
Spray arms
It is necessary to clean the spray arms regularly for hard water
chemicals will clog the spray arm jets and bearings�
To clean the spray arms, follow the instructions below:
To remove the upper spray
arm, hold the nut in the center
still and rotate the spray arm
counterclockwise to remove it�
To remove the lower spray
arm, pull out the spray arm
upward�
Wash the arms in soapy and warm water and use a soft brush to
clean the jets� Replace them after rinsing them thoroughly�
Caring for the dishwasher
Frost precaution
Please take frost protection measures on the dishwasher in
winter� Every time after washing cycles, please operate as
follows:
1� Cut off the electrical power to the dishwasher at the supply
source�
2� Turn off the water supply and disconnect the water inlet pipe
from the water valve�
3� Drain the water from the inlet pipe and water valve� (Use a pan
to gather the water)
4� Reconnect the water inlet pipe to the water valve�
5� Remove the filter at the bottom of the tub and use a sponge to
soak up water in the sump�
After every wash
After every wash, turn off the water supply to the appliance and
leave the door slightly open so that moisture and odors are not
trapped inside�
Remove the plug
Before cleaning or performing maintenance, always remove the
plug from the socket�
79
78
GB
GB
