DAMPER
ORING
Box 2, Bag for page 34
Main Blade
[S501]
Tail Blade
[S80]
OPERATIONS BEFORE FLIGHT
*Set up the remote control and the flybarless system with utmost care.
*It is advisable to test the correct settings of the remote and flybarless system without main blades or tail
blades fitted.
*Check that all wiring is isolated from the carbon/aluminum parts. It is good practice to protect them at the
points where they are at most risk.
*Be sure of the gear ratio, verifying carefully the motor pulley in use. The forces acting on the mechanics
increase enormously with increase of rpm. Although the Goblin can fly at high rpm, for safety reasons we
suggest to not exceed 33
00rpm
.
*Fit the main blades and tail blades. (
Figure.1
and
Figure.2
)
*Please make sure the main blades are tight on the blade grips, you should be able to violently jerk the head
in both directions and the blades should not fold. Failure to tighten the blades properly can result in a boom
strike. To fold the blades for storage, it is advisable to loosen them.
*Check the collective and cyclic pitch. For 3D flight, set about +/-13°.
*It is important to check the correct tracking of the main blades.
On the Goblin, in order to correct the tracking, adjust the main link rod. This is provided with a right/left
thread system that allows continuous fine adjustments of the length of the control rod; for this adjustment it
is not necessary to detach the ball link.
*Confirm the canopy is secure prior to each flight.
*Make sure that the battery locking pin is back in its resting position, blocking in correct way the battery tray.
*Perform the first flight at a low headspeed, 2400 RPM.
After this first flight, do a general check of the helicopter. Verify that all screws are correctly tightened.
IN FLIGHT
ABOUT HEAD
The dampers are composed of 2 O-ring ( that defines the rigidity ) and a technopolymer damper
(that defines the maximum possible movement of the spindle).
Using different Oring and dampers you can get different responses of the model.
H1822-A
= Max movement of the spindle, feeling more elastic.
H1822-B
= Medium.
H1822-C
= Min movement of the spindle, feeling more direct.
Inside the Spare parts H1822-S you can get all options.
Socket Head Cap
Shoulder M3x16mm
(HC074-S)
Socket Shoulder
Screw M4x24mm
(HC111-S)
Nylon Nut M4
(HC212-S)
Nylon Nut M3
(HC206-S)
Page 34
IN FLIGHT
Summary of Contents for GOBLIN RAW 500
Page 1: ...MANUAL GOBLIN 500...
