32 025 940 9
Saab 9-3
30
M08:
Drill 8 mm holes (from the inside of the
bumper shell) in the centre of each marking
(x 4).
Position the hole-punching tool from the outside
of the bumper. Grip on the outside, at the same
time tighten the nut from the inside until the
hole-punching tool is pressed through the whole
of the bumper shell. Carry out the hole-making
procedure for all four holes.
Fit the tape and holders for the sensors in
accordance with the markings in the bumper
shell.
Important
The connector sockets for the distance sensors
should point towards the right-hand side of the car.
F930A633