12 832 515 9
Saab 9-3 CV M04-
30 Position the left-hand front seat in its most
forward position and fold the backrest forwards.
31 Take the fibre optic cable, A-pillar - Torsion
compartment, from the kit and guide it from the
connector at the left-hand lower A-pillar via the
wiring harness by the scuff plate, under the rear
seat and to the left-hand roll-bar in the torsion
compartment. Secure the fibre optic cable with
cable ties.
32 Raise the soft top completely and open the boot
lid.
Note
The seat must be pushed to the rear position in
order to access the whole route. Following which,
push the seat back to the forward position.
Important
Handle the fibre optic cables with care or the
signal may be distorted.
·
Do not bend the cable in a radius smaller than
25 mm.
·
The cables must not be exposed to knocks
which cause the transparent plastic to whiten,
which means that the light intensity is weak-
ened. Such damage can cause an interruption
to communication.
·
The cable should not lie against any sharp
edges as this may cause increased signal
reduction.
F930A308
31
31
31
