48
Saab TankRadar L/2
US Version. Seventh edition, June 1995
Installation Manual
7.
Place a customer supplied gasket on
the flange of the still pipe.
8.
Mount the assembly into the still
pipe. Use only manual force. Too
much force can damage the Cone.
Mount customer supplied screws
and nuts and tighten. Make sure the
Cone is centered in the still pipe. Fit
the M16-nut and tighten.
M16 nut
and
washer
Flange
Cone
Stand
Still pipe
Customer´s
gasket
O-Ring
Waveguide
Unit
Transmitter Head
Four M10 nuts
and washers
Transmitter
Head
Stand
Cables
pointing
down
Note:
Guide
pins
10.
Slide the Waveguide Unit into the
Transmitter Head. It can only be
entered in one way.
11.
Mount the Transmitter Head onto
the Stand with its cable connections
pointing down. Be careful not to
drop the Waveguide Unit as it is not
in i fixed position. Check that the
guide pins on the Stand enter the
holes on the base of the Transmitter
Head properly. Fit and tighten the
M10 nuts.
12.
The Waveguide Unit will not be in a
fixed position until the Transmitter
Head has been tightened to the
Stand.
Spring
Sleeve
9.
Mount the Spring Sleeve into the
baser of the Transmitter Head. Turn
the Spring Sleeve so that it fits into
one of the notches.
