SA Saunum Premium, Instructions For Installation And Use Manual

Page: 7 / 165

12 13
HEATING
THE SAUNA ROOM
Before using the sauna climate device for
the first time, make sure that:
• the electrical connections meet the
requirements;
• the supply voltage corresponds to
the nominal ratings allowed for the
sauna climate device;
• the protective earth (PE) is in work-
ing order;
• the fasteners of the housing of the
device are in order;
• the sauna climate device is pro perly
attached to the wall and the wall
can bear the weight of the device
together with the stones;
• the over-current fuses are in working
order;
• the fan rotor rotates smoothly;
• there are no tools or materials left
inside the housing of the device after
installation.
When switching the sauna climate device
on, check:
• the direction of the air flow – the air
intake from the upper and the out-
put from the lower opening;
• that there is no vibration or excessive
noise when the fan is running.
When the sauna climate device is switched
on for the first time, the heater and the
stones will emit an odour. The sauna room
must be properly ventilated to remove the
odour.
If the power of the heater is suitable for the
size of the sauna room, it takes 45–90 minu-
tes in a properly insulated sauna room to
reach the desired temperature. The stones
are usually heated to the steam tempera-
ture at the same time as the sauna room.
Switch the fan on just before entering the
sauna room – this will help to prevent the
sauna bench from overheating and avoids
excessive energy consumption.
Saunum’s
recommended temperature for sauna
operation is 65 °C to 80 °C.
USING THE SAUNA
CLIMATE DEVICE
NB!
Before switching the sauna climate
device on, always make sure that nothing is
above or near it.
The operating time of the
Saunum
Premium sauna climate device can be
adjusted by a separate control device.
• Do not connect the device directly to
the mains!
• The sauna climate device must not be
used if the components of its housing
have been removed and/or the wiring
diagram has been changed.
• Children should not be allowed to
access or play with the sauna climate
device.
• When switching the sauna climate
device on and off, follow the instruc-
tions for use of the control device
you are using.
NB! After using the sauna, make sure that
all parts of the sauna climate device are
switched off (both the heating and the fan
have stopped).
ADJUSTING
THE TEMPERATURE
NB! It is recommended to keep the fan
of the sauna climate device switched off
during the heating of the sauna room!
In this case, the sauna room heats up faster
and the sauna bench does not get too hot
during the heating. To find the right setting,
start testing at the lowest temperature and
lowest air flow speed. If the temperature
becomes too high while you are in the sau-
na room, reduce the maximum tempera-
ture or lower the speed of the fan of the
climate device.
ADJUSTING THE
SAUNA CLIMATE
The amount of air circulation generated by
the device is adjusted by a switch located
on the front of the device, on the left of the
lower part. The switch has four positions
and may be turned both clockwise and
counter clockwise. When the stripe on the
switch points to the left, the fan of the sauna
climate device is switched off.
The air flow speed increases by turning
the switch clockwise, you may choose be-
tween three different speeds. For adjusting
the air temperature in the sauna room,
there is a cooling damper on the left side
of the flue plinth behind the stone basket
(see page 27). It is recommended to keep
the cooling damper 1/3 open. To cool the
steam, try to open the damper little by little.
USE OF
HIMALAYAN
SALT BALLS
The sauna climate device comes with Hima-
layan salt balls. The use of salt balls in the
device is optional and does not affect the
main function of the device.
The salt balls must be installed into the
sockets between the air outflow grille and
the fan. Make sure that the salt balls are
instal led correctly and do not impede the
fan rotation.
To install or remove the salt balls, remove
the air outflow grille (see page 34) and
place the salt balls into their sockets. After
installing or removing the salt balls, reposi-
tion the grille. The sauna climate device
may only be used with the air outflow grille
in place! Do not use/start the device if the
salt balls get into the fan housing!
NB! The use of third-party salt balls is not
covered by the device warranty.
INSTR
UC
TIONS
FOR USE
INSTR
UC
TIONS
FOR USE