5
DURING USE
- OPERATING THE SA POWERNET EX MDU
Position and set up the MDU according to the previous instructions
Check that the MDU is safe for use and has no defects, paying particular attention to the external
cables and the electrical enclosures.
The MDU can then be connected to the correct supply. The supply voltage should be within the voltage
range shown on the product type label.
The supply voltage should not vary by more than +/-10% of the voltage on the product type label.
Ensure that the load of the equipment connected to a socket/ or pair of sockets does not exceed the
maximum rating of the secondary MCB fitted.
If the MDU stops functioning or does not switch on, it should be taken into safe area before inspecting
the control box. The MDU contains circuit breakers which may stop the unit functioning in the event of
a fault.
If the MDU gets damaged during use it must be immediately disconnected from the supply and
removed to a safe area for inspection and test. Correct use of the equipment should help to ensure
that it is not damaged. If you would like more information on ancillary products, please contact the
Sales Team on +44 333 240 6111 or [email protected].
AFTER USE
- INSPECTION & MAINTENANCE PROCEDURES
Maintenance may be carried out only outside the EX area
Isolate the MDU unit from the mains supply and allow to cool before carrying out any maintenance
work.
The MDU should be cleaned when necessary using a damp cloth. If necessary use neutral soap. No
detergents or solvents are allowed. Do not allow dirt and/or dust to accumulate on the equipment.
Operator is responsible to comply with the all applicable regulations including: EN60079-14,
EN60079-17 and EN60079-19
Basic repairs can be carried out by a competent electrician in accordance with the detailed instructions
– available on request.
No user modifications are permitted and only original spares from SA Equip must be used. The use of
any other parts will invalidate any warranty and could compromise the safety and functionality of the
equipment.
Maintenance instructions, exploded-view diagram and spare parts list are available on request. SA
Equip offer a full repairs service. Contact the SA Service Centre on +44 (0)333 240 6111 for more
details.
