Step 3
C
D
1
2
7
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (C and D). Use twelve 1/2"
FLAT HEAD SCREWS (21).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to fi nd the other hole that lines up with the hole in the ENDS.
Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Push the black lever up and pull the SLIDE from the RAIL.
Open end
Open end
Use these holes.
1/2" FLAT HEAD SCREW
(12 used in this step)
21
Page 8
www.sauder.com/service
426275
1
1
1
1
