1
Set Up: Start Up Instructions
1. Main Air Supply.
*Open valve slowly after attaching air.
2a. Regulator (Main Air):
Factory set at 80 PSI.
2b. Main air gauge.
3a. Regulator (Squeegee/Print head):
Factory Set at 30 PSI.
3b. Squeegee air gauge.
4. Regulator (Carriage Up-Down):
*Used for the overhead cylinder on printer
carriage.
Factory set. (Ref Page 2 item number
3 for carriage speed adjustment).
Keep locked.
5. Air Filter:
Separates water from air.
Unscrew bottom plug to drain.
6. Air Lubricator:
Keeps pneumatic components lubricated
*Be sure to use specific air tool oil. Fill plug
located on top. Turn smaller cap to loosen.
*Failure to use proper oil will result in damage to
valve, hoses, and cylinder seals.
*Maintain approximately ¾ full.
7. Foot Pedal:
Depress pedal once to perform one print cycle.
8. Locking Pin:
Pull L-pin out to drop screen for cleaning and
maintenance.
*Refer to page 4 item number 1 for screen
adjustment instructions.
