S2Konnect N-2020T
10
5
3.
At the other end of the cable connect the connector to the port on the network device.
The port type (e.g. 1000Base-T) on the network device and that in the S2Konnect
Network Card must be identical.
4.
Reconnect the Switch and other units to the power supply.
5.
Turn on the network device and the Switch or other station.
6.
Check the SPD/LNK/ACT LED belonging to the port you plugged in the plug to find out if
the cable is connected correctly.
If the LED is on, the connection is established and active. Otherwise you have to check
the S2Konnect units more closely (for details, refer to section “LED Displays” on p. 19).
Hardware Features
The S2Konnect N-2020T 10/100/1000Base-T Network Interface Card are designed for easy ins-
tallation and high performance in environments with varying traffic loads and multiple users.
The network cards can be connected to different equipment in the network
.
Connections maybe done with different backgrounds, such as aggregation connections to get a
higher throughput, establish redundant connections for failover or connect the cards with each
ports to different networks for routing or inspection purposes.
Connection options:
1.
Redundancy (Redundant Link Management Technology)
One port is active and all trafic is going through that port, a second port is active but
without traffic.
If active port is disconnected or any infrastructure (cable, switch...) that is between the
adapter an network is damaged the other port will take over.
(please refer to Redundant Link Management Technology installation on the software
readme file).
2.
Link Aggregation
LAN
Figure 2. Picture RLMT
Figure 3. Picture Aggregation
