11
24
SRAM BLIP BOX
WIRES GOING
TO BASEBAR
AND EXTENSION
SHIFTERS
M4 x 6.5mm BOLT
FIG. 24 (SRAM AXS):
Route the basebar and extension wires:
•
Route the basebar wires individually to each lever.
•
Route the extension wires the same way as Di2.
•
Install the SRAM AXS Blip Box on the underside of the basebar, then route
the wires through the large round hole on the underside of the basebar, then
plug the wires into the Blip Box.
25
ARMREST CUP BOLTS
ARMREST CUPS
FIG. 25:
Install the armrest cups.
•
Install the armrest cups (4 x M5 x 8mm bolts) in the desired position, then
place the armrest pads onto the armrest cups.
•
Finish the brake and shifter setup according to the brake manufacturer’s
instructions.
26
EXTENSIONS
MINIMUM INSERTION
FIG. 26:
Install the extensions.
•
Insert the extension shifter wires in the extensions until they exit the ends of
the extensions.
•
Route the extension shifter wires through the extensions (loosening the stack
bolts can help). Depending on the shifters, the wires will either have the exit
the hole at the end of the extensions, or out a side hole.
•
Once routed, insert the extensions into the extension sockets.
WARNING! Make sure the extensions are inserted past the MIN
mark etched on the side of the extension sockets.
•
Plug the wires into the shifters and install the shifters according to the shifter
manufacturer’s instructions.
•
Adjust the angle and insertion depth position of the extensions, then torque
the extension bolts to 22 in-lbf / 2.5 Nm.