13
W i r e l e s s R e m o t e O p e r a t i o n
The RF remote system requires no complex programming and is shipped ready to use. In the event that
another WPC unit or similar device is installed nearby and is operating on the same pairing code, that
code (A-P) may be easily changed by choosing another via the 4 position DIP switch package found inside
the battery compartment of the remote. The receiver board inside the control panel will also need to
be changed to match.
Note:
The default code as shipped is Code A on both the remote
and the receiver.
Sleep Mode
To conserve battery power, the remote will enter standby mode
when no function has been selected for 30 seconds or more.
To wake the remote, simply press the ‘1, 2, S, or M’ button
momentarily. The indicator will light up solid for 5 seconds
indicating that it is ready to transmit. A rapidly flashing indicator
indicates that a command signal was sent to the control panel.
To Turn On Using the Wireless Remote Operation
Push the button marked (1) ‘ON/OFF – COLOR CHANGE’ to
toggle on and off the power of Zone 1 on the WPC panel.
Push the button marked (2) ‘ON/OFF – COLOR CHANGE’ to
toggle on and off the power of Zone 2 on the WPC panel.
Color Changing Operation
To change LED pool light colors simply toggle the power OFF,
then ON using the button marked ‘1 or 2’ within 1 second.
Continue toggling until the desired color or light show is reached.
To operate both zones together simultaneously, use the ‘M’
(master) button on the remote.*
NEW FEATURE
1-Button - Color Sync / Reset Operation
(For use only with SR Smith LED kelo, Treo, FG, Treo Micro &
LED water features)
To color synch lights in a multi-light installation (single or dual
zone), simply press the “S” button once and wait 15 seconds.
During this time, the lights will flash on and off several times,
pause in the off mode, then finally resume at color mode 1
(soft color change).
*Note:
Both toggle switches on the WPC unit must be set to
REMOTE for wireless operation.
Performance Note:
For best results, hold the remote
vertically (pointed at the sky) when pressing the
command buttons.
PAIRING CODE CHART
DIP Switch
1
2
3
4
Code A
OFF OFF OFF OFF
Code B
ON OFF OFF OFF
Code D
OFF ON OFF OFF
Code C
ON ON OFF OFF
Code E
OFF OFF ON OFF
Code F
ON OFF ON OFF
Code G
OFF ON
ON OFF
Code H
ON ON
ON OFF
Code I
OFF OFF OFF ON
Code J
ON OFF OFF ON
Code K
OFF ON OFF ON
Code L
ON ON OFF ON
Code M
OFF OFF ON ON
Code N
ON OFF ON ON
Code O
OFF ON
ON ON
Code P
ON ON
ON ON
Summary of Contents for WPC1 Series
Page 2: ...2...
