ASSEMBLY INSTRUCTIONS
1. Begin by locating the rear frame, front cross
tubes (2), and the split tees as shown in
FIGURE 3.
Attach front cross tubes to the rear
frame by sliding over the inserts as shown in
FIGURE 3
. (Do not bolt cross tubes in at this
time) Attach (4) split tee halves at the top of the
rear frame using (4) 3/8”x2-1/2” carriage bolts
and (4) 3/8” hex nuts. NOTE: Do not tighten any
hardware until final step.
Stand rear frame up and attach both front rails
by inserting the top into the split tees already on the
rear frame and the stainless inserts into the front
cross tubes. See
FIGURE 4
2. Attach the four 15
q
white steps using the
supplied pre-packaged hardware. Each
step is fastened using (2) 3/8” Cradle
head bolts, 3/8” flat washers, and 3/8”
hex nuts. See
FIGURE 4
.
3.
Attach footboard to both cross tubes using
(4) 3/8”x4” carriage bolts, ½” flat washers,
3/8” lock washers, and 3/8” hex nuts.
Attach the two bottom rails with (8) split
tee halves, 3/8” x 2-1/2” carriage bolts and
3/8” hex nuts. See
FIGURE 5
.
5
FIGURE 5
32
32
18
22
16
FIGURE 3
23
29
27
18
28
26
25
23
FIGURE 4
15
9
17
18
16
32
32
18
24
3