15
23)
If necessary the legs can be adjusted up and down within the leg sockets to help
adjust for level. Once the slide is properly leveled the legs shall be permanently
attached by drilling a 1/4" hole into each leg using the hole on the leg socket as a
guide and fastening with a (#10) 5/16” Hex Head Washer Tek Head Screw. See
Figure 22.
24)
Disassemble each handrail as shown in Figure 23. Insert the two handrails into
the holes on the top of the slide runway rails, and secure each using a (#21) Flat
Washer, a (#19) Lock Washer, and a (#20) Hex Nut.
25)
Starting with the top handrail spacer, align the top hole in the handrail with the
top hole in the ladder side rail. Next, assemble the handrail spacer parts (#16),
(#17) and (#18) in the order shown in Figure 23 and align it between the handrail
and ladder top holes. Next, insert the (#15) 1/4-20 x 8” Carriage Bolt through the
handrail and the handrail spacer parts. The (#9) Ladder spacer is to be placed in
between the front and back sides of the ladder side rail such that the (#15)
Carriage Bolt holds it in place after it is pushed completely through the ladder
side rail, see Figure 24. Secure the (#15) Carriage bolt using a (#21) Flat
Washer, a (#19) Lock Washer, and a (#20) Hex Nut in the order shown in Figure
23. Finally, place a (#6) Vinyl Bolt Cap over the exposed threaded end of the
bolt.
26)
For the remaining two ladder spacers, align parts (#16), (#17) and (#18)
between the hole in the handrail and the hole in the ladder as in step 24. Use a
(#14) 1/4-20 x 6” Carriage Bolt along with a (#21) Flat Washer, a (#19) Lock
Washer, and a (#20) Hex Nut to fasten the parts together as shown in Figures 23
and 24. Again, place a (#6) Vinyl Bolt Cap over the exposed threaded ends of
the bolts.
Figure 22