700-9000
6.14.13
16
Follow these guidelines to make sure that your anchor jig is installed properly:
1. Minimum concrete slab requirements for the multiLift™:
Slab dimensions should be at least 42” X 60” X 4”, see Figure 15 above.
Anchors shall be installed at a minimum of 4” or greater from the edge of the slab or
expansion joint.
Normal weight of concrete = 150 lbs/ft^3
Concrete minimum compressive strength at 28 days to be F’c =2500 psi.
Reinforcing bars shall conform to ASTM A615 Grade 60, deformed.
2. Use
Figure 10 and Table 1 to determine the proper location to install the lift, making certain that
the front anchors are located the correct distance from the pool edge.
3. Assemble the deck anchors to the anchor jig as described in Appendix E.
4. Install the anchor jig and reinforcing rods per Figure 15.
5. Use the bonding lug provided on the anchor jig to attach the bonding wire per local codes.
Contact your local Authority having jurisdiction for the bonding requirements in your area.
6. Make sure that the top of the anchors are flush with the top surface of the slab.
7. Allow concrete to cure per manufacturer’s instructions.
8. Once the concrete has cured, install the lift per the installation instructions.
STANDARD ACCESSORIES/OPTIONAL ACCESSORIES
The following items are included with all pool lift models:
.
Seat Belt Assembly - Nylon water-resistant belt for added security.
Battery/Charger – 24-volt rechargeable battery.
Optional accessories may be purchased for your multiLift™ lift through your Authorized Reseller. The
following accessories are available:
Console/Battery Cover – P/N 910-1000: Protects battery and control unit from exposure to moisture
Stability Vest - P/N 900-2000: Five point restraint for individuals who need higher degree of stability than
provided with standard seat belt.
Total Cover - P/N 575-5100: Made of weather resistant nylon material to keep unit protected from
elements when not in use.
Arm Rest Assembly – P/N 170-1000: Powder coated stainless steel arm rests for increased sense of
security. Reference Appendix C for details
.
Seat Pad - P/N 890-1000: Waterproof seat pad designed to enhance comfort during transfer.
multiLift™ Deck Anchor Kit P/N 300-6700A – Includes 4 flush deck anchors.
New Construction Anchor Jig P/N 500-5000 – Includes anchor jig, and hardware minus the flush deck
anchors. See anchor jig assembly info Appendix E.
Wheel-A-Way Option P/N 500-5500- Although the multiLift™ must be installed in stationary deck
anchors, it can be transported using the multiLift™ Wheel-A-Way transport wheels (optional). The Wheel-
A-Way transport wheels are designed to facilitate moving the multiLift™ from one anchor location to
another, or to a storage area. See Appendix F for details.
Lift Operator Single Channel Controller with Activation Key P/N 1001545 – Activation key can be
used to prevent unauthorized use of the lift. For more information on the control unit with activation
key see the LiftOperator Owner’s Manual, P/N 700-0500.
