11
9.
Lay the ladder assembly on the ground with the steps facing down as shown in FIGURE G. Lift the
upper runway section and align the threaded studs sticking out of the top ladder section with the
holes in the upper runway section. Attach the runway to the ladder using the hardware shown in
FIGURE G. Tighten until the lock washer is fully compressed.
Notes: It may take more than one person to perform this step. Verify that the gasket material
is properly attached before assembling the parts. Be sure to apply anti-seize to all fasteners
to prevent galling.
10.
Apply a .25 inch (6 mm) bead of Silicone sealant (Silicone II or similar) around the base of the cone of
the slide’s center column. See FIGURE H.
FIGURE G
APPLY .25” (6MM) BEAD OF SILICONE
FIGURE H
(4)
(1)
(2)
Summary of Contents for heliX2
Page 19: ...A APPENDIX A...
Page 20: ...B APPENDIX B...
