Spin the knob from the left to right, the gyro intervention gains value 0-100%.
①
GAIN
When the power on, long press the
【
SET
】
3 seconds, the LED from red to green
or from the green to red, it means the switch is successful. (Red LED is on for
Normal, Green LED is for Reverse)
1. Reverse/Normal Switching
2. EPA (End point adjustment)
②
SET
!
The default direction of servo is Reverse. If not modified, please keep the
red constant LED light as normal state.
!
Before setting, please make sure the gyro direction is the same as the
direction of vehicle steering.
③
LED status
Power on fast flashing
Gyro initialization (time about 2 seconds).
No Transmitter signal.
LED
Status
Slow flashing
Red on
Working
，
gyro direction is Reverse.
Green on
Working
，
gyro direction is Normal.
Fast Flashing
In EPA Setting.
a. Before power on, press and hold
【
SET
】
, then turn on the vehicle power (please release
【
SET
】
ASAP
after turning on the power, if more than 5 seconds, it will restore the factory setting), LED red flashing, it
enters into the EPA setting.
b. Rotate the remote control rudder, turn the rudder to the desired position (to the left or right), keep the
current state, short press
【
SET
】
then the green LED flashing, it completes the single-side EPA setting.
c. Rotate the remote control direction rudder to turn the servo to the desired position in another direction and
keep the current state, short press
【
SET
】
and the red and green LEDs will flash (about 2 seconds). When
the LEDs will be on, the EPA setting is finished.
* Restore factory setting: Before power on, press the
【
SET
】
, then hold for 5 seconds after power on, the
red LED and green LED will flash at the same time, then return to default setting (default
1100us-1900us).
- 5 -
