![background image](http://html1.mh-extra.com/html/velleman/trcv3a/trcv3a_manual_4049476001.webp)
TRCV3A/B
1 VELLEMAN
TRCV3A/B – RADIO-CONTROLLED MINI TRUCK
1. Introduction & Features
Thank you for buying the TRCV3! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual or by user modifications is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
•
Avoid using your TRCV3 near another R/C vehicle being operated, portable phones, electrical lines, CB's etc.
•
When radio transmission is decreasing, replace the batteries.
•
Remove the batteries from the remote control when the TRCV3 is not going to be used for a longer period of time.
•
Only use the TRCV3 in safe circumstances, not on roads, in crowded places or near playing children.
•
Handle the truck, the remote control and the batteries with care.
•
Keep fingers, hair and loose clothing away from moving wheels.
•
Children under 5 years of age must be assisted by an adult when using the TRCV3.
•
Keep this manual for future reference.
3. Remote Control Lay-out
1. Antenna
2. Charging indicator
3. Operating indicator
4. Forward
5. Reverse
6. Left
7. Right
8. Charging station
4. Use
•
Slide off the battery compartment cover and insert 4 AA alkaline batteries in the battery compartment (at the back
of the remote control). Close the battery compartment.
•
Insert the antenna in the hole at the top of the remote control. Turn the antenna clockwise to secure it.
•
To charge the truck: open the charging station (#8) and put the truck on the station. The charging indicator (#3)
will light up when the truck is being charged. After a full charge (approx. 1 minute), the indicator will extinguish.
Take the truck off the remote control and close the charging station.
•
Put the truck on a smooth and dry surface and fully extend the antenna on the remote control. Press the forward
(#4) or reverse (#5) button to make it go forward or backward. Press the left (#6) or right (#7) button while
pressing the forward or reverse button to make it turn. Pressing left or right when the truck is not in motion will not
have any effect.
•
The operating indicator lights up when the remote control is in use. When the indicator light becomes weak,
replace the batteries.
•
Occasionally the truck will sway to the left or the right while moving forward or backward.
Correct the alignment with the direction adjustment as shown in the figure at the right.
The information in this manual is subject to change without prior notice.