18
FIGURE 16
15.
CUTTER SHAFT LOCK
To remove the cutter you must lock the cutter and cutter shaft in position before using a wrench to remove
the cutter.
Press DOWN firmly on the cutter shaft lock (small round black knob). While holding the knob down rotate
the cutter by hand until the cutter shaft lock “clicks” into position. When turning the cutter by hand there is
only ONE locking position. You may now proceed with removing the cutter shaft lock nut and the cutter.
PLEASE… DON’T FORGET
to pull UP on the cutter shaft lock when you are finished reinstalling the
cutter wheel. Pulling UP on the cutter shaft lock releases the cutter and cutter shaft from the locked
position. Failure to unlock the cutter when attempting to cut a key will result in no rotation of the cutter.
Please note-
However-the motor may be powerful enough to slip the belt and permanently damage it by
wearing a flat spot on the belt.
16.
Removing/Replacing the Cutter
REMOVING THE CUTTER
The cutter wheel is secured to the cutter shaft with a
LEFT-HAND NUT.
You must turn the nut to
the
RIGHT
(facing the cutter wheel) to remove it. See figure 17 below
Remember to LOCK the cutter before removing the cutter wheel.
Use a 1” open-end or hex wrench to remove the Left-Hand Nut. See figure 17.
Summary of Contents for RY256
Page 2: ...2...
