Ryobi VC722, Operator'S Manual

Page: 8 / 14

8
TO CHARGE HAND VAC USING CRADLE
See Figure 5.
■
Charge hand vac only with the charger provided.
■
Place hand vac in cradle ensuring that charger plug,
previously installed, is correctly connected to input
jack of the hand vac’s battery pack.
See Figure 5
■
Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
■
Connect charger to power supply.
OPERATION
MOUNTING THE CRADLE AND CHARGING
THE HAND VAC
See Figures 3 and 4.
WARNING:
When mounting the cradle, make sure you will not
come in contact with any internal electrical wiring in
the wall. Any contact with wiring may cause a fire or
electrical shock.
■
Position the cradle in place, and secure it to the wall
with the two (2) screws provided.
See Figure 4.
Fig. 4
Fig. 5
NOTE: Before the cradle can be mounted to the wall, you
must install the input jack into the back of the cradle.
■
Locate a convenient wall stud to mount the cradle
near an electrical outlet. Use charger with normal
household voltage of 120 volts, 60 Hz. AC only. Tem-
porarily place the hand vac in the cradle to make
sure it is mounted high enough to keep the unit off
the floor or countertop and will not interfere with the
charger or electrical outlet.
■
Use a pencil to mark the position of the two mounting
holes on the wall. Make sure the cradle is the correct
vertical position.
■
Insert spacer and charger plug into input jack on back
of cradle arranging wire as shown. Place clamp on
top to secure charger plug and install the screws into
the two mounting holes. Tighten screws securely.
CAUTION:
To prevent injury or damage to the unit, the cradle
must be mounted securely to the wall.
A charging cradle has been supplied with your hand vac
for easy storage and charging. To utilize the cradle, it has
to be mounted to a wall.
CHARGING CRADLE
OPERATION
Fig. 3
SCREWS
CRADLE
CHARGER PLUG
SPACER
SCREWS
CLAMP
CHARGER PLUG INSTALLED
INPUT JACK
CHARGER PLUG
CRADLE
HAND VAC