![background image](http://html1.mh-extra.com/html/ryobi/ts1142l/ts1142l_operators-manual_1506642018.webp)
18
ASSEMBLY
NOTE:
Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so
that we can clearly show points being made in the illustra-
tions.
Never operate the saw without all guards securely
in place and in good operating condition.
SQUARING THE BLADE TO THE FENCE
See Figures 15 - 18.
Unplug the saw.
Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
Unlock the miter lock lever.
Rotate the miter table until the pointer aligns with zero
on the miter scale.
Lock the miter lock.
Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
NOTE:
Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
The edge of the square and the saw blade should be
parallel as shown in figure 16.
If the front or back edge of the saw blade angles away
from the square as shown in figures 17 and 18, adjust-
ments are needed.
Using the blade wrench, loosen the socket head screws
that secure the miter fence to the miter table. See figure 15.
Rotate the miter fence left or right until the saw blade is
parallel with the square.
Retighten the screws securely and recheck the blade-to-
fence alignment.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero.
See figure 19.
Fig. 16
MITER
TABLE
VIEW OF BLADE SQUARE WITH FENCE
SQUARE
VIEW OF BLADE NOT SQUARE WITH FENCE, ADJUSTMENTS
ARE REQUIRED
Fig. 17
Fig. 18
VIEW OF BLADE NOT SQUARE WITH FENCE, ADJUSTMENTS
ARE REQUIRED
MITER
FENCE
BLADE
MITER
TABLE
SQUARE
MITER
FENCE
BLADE
MITER
TABLE
SQUARE
MITER
FENCE
BLADE
MITER
LOCK
LEVER
Fig. 15
MITER
FENCE
SOCKET HEAD
SCREW(S)
SOCKET HEAD
SCREW(S)
Summary of Contents for TS1142L
Page 31: ...NOTES NOTAS...