![background image](http://html1.mh-extra.com/html/ryobi/ts1142l/ts1142l_operators-manual_1506642014.webp)
14
ASSEMBLY
WARNING:
Always make sure the compound miter saw is securely
mounted to a workbench or an approved workstand. Fail-
ure to heed this warning can result in serious personal injury.
MOUNTING HOLES
See Figure 8.
If not using a stand, the saw should be mounted to a firm
supporting surface such as a workbench. Four bolt holes have
been provided in the saw base for this purpose. Each of the
four mounting holes should be bolted securely using 1/4 in.
machine bolts, lock washers, and hex nuts (not included).
Bolts should be of sufficient length to accommodate the
saw base, lock washers, hex nuts, and the thickness of the
workbench. Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in
figure 8. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
TO INSTALL/REPLACE THE BLADE
See Figures 9 - 10.
WARNING:
A 7-1/4 in. blade is the maximum blade capacity of the
saw. Never use a blade that is too thick to allow outer
blade washer to engage with the flats on the spindle.
Larger blades will come in contact with the blade guards,
while thicker blades will prevent the blade bolt from se-
curing the blade on the spindle. Either of these situations
could result in a serious accident and can cause serious
personal injury.
Unplug the saw.
Raise the saw arm.
Rotate lower blade guard up and remove blade bolt cover
screw. Rotate blade bolt cover up and back to expose
the blade bolt.
Depress and hold the spindle lock button and rotate the
blade bolt until the spindle locks.
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
Fig. 8
Fig. 9
MOUNTING
SURFACE
BASE
SPINDLE LOCK
BUTTON
Summary of Contents for TS1142L
Page 31: ...NOTES NOTAS...