Ryobi RYi2200H, Operator'S Manual

Page: 15 / 64

15 — English
OPERATION
NOTE: To prevent short circuit, keep away from a metal
surface during clamp connection.
 Connect the battery charging cable assembly to the
12 V DC receptacle.

Start the generator.
NOTE:
The AC receptacles can be used while the DC
receptacle is in use.

The battery will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
NOTE:
Only use battery charging cable assembly to
charge vented wet lead acid batteries.

When battery becomes fully charged, disconnect the
battery charging cable assembly from the battery.
Disconnect the negative (black) wire first, then the positive
(red) wire, being careful not to short across the terminals.
Always abide by the safety warnings provided with the
battery.
NOTE:
Most batteries will be completely charged after
30 to 120 minutes. However, it is highly recommended
that you refer to your battery manufacturer’s instructions
for specific charge times.

Unplug battery charging cable assembly and store for
later use.
MOVING THE GENERATOR
See Figure 9.

Place the engine choke lever in the off position. At the
off position, the fuel valve will be closed and prevent any
gas flow.

Allow 30 minutes of “cool down” time before storing the
machine.

Pull the retractable handle out or carry by the carry handles.

Facing the front of the generator, grasp the folding handle
firmly with one hand.

Lift the generator toward you until it balances on the
wheels.

Turn around and pull the unit along behind you to the
desired location.

Lower the generator until it sits securely on a flat surface.
HIGH ALTITUDE OPERATION
Your engine is configured for operation below 2000 feet
altitude at the factory. Your engine must be reconfigured for
operation above 2000 feet altitude. Operating the engine
with the wrong engine configuration at a given altitude may
increase its emissions, decrease fuel efficiency, degrade per-
formance and cause irreversible damage. Engines configured
for high altitude operation cannot be operated in standard
altitude conditions. A qualified service center should ensure
that your engine is properly configured for your location.
Normal maintenance, replacement or repair of emission con-
trol devices and systems may be performed by any qualified
repair establishment or individual with original or equivalent
parts. Warranty and recall repairs must be performed by an
authorized service center; please contact customer service
for assistance.
WARNING:
When servicing, use only recommended or equivalent
replacement parts. Use of any other parts could create
a hazard or cause product damage.
WARNING:
Before inspecting, cleaning or servicing the machine, shut
off engine, wait for all moving parts to stop, and disconnect
spark plug wire and move it away from spark plug. Allow
30 minutes of cool down time before performing any
maintenance. Failure to follow these instructions can result
in serious personal injury or property damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualifed service center for assistance.
GENERAL MAINTENANCE
Keep the generator in a clean and dry environment where it
is not exposed to dust, dirt, moisture, or corrosive vapors.
Do not allow the cooling air slots in the generator to become
clogged with foreign material such as leaves, etc.
Do not use a garden hose to clean the generator. Water
entering the fuel system or other internal parts of the unit can
cause problems that will decrease the life of the generator.
To clean the unit:

Use a soft bristle brush and/or vacuum cleaner to loosen
and remove dirt and debris.

Clean air vents with low pressure air that does not exceed
25 psi.
MAINTENANCE