![background image](http://html1.mh-extra.com/html/ryobi/ry405010/ry405010_operators-manual_1504246023.webp)
23 - English
BAR
GROOVE
CHAIN DRIVE
LINKS
Fig. 27
CHAIN
TENSION PIN
HOLE
ADJUSTING
PIN
Fig. 28
BAR STUDS
BAR
MOUNTING
NUTS
CHAIN
COVER
NOTE:
When replacing the guide bar and chain,
always use the specified bar and chain listed in
the
Bar and Chain Combinations
section later
in this manual.
Remove the battery pack before you do any
work on the chain saw.
Remove the bar mounting nuts using the
combination wrench provided.
Remove the chain cover.
Remove the bar and chain from the mounting
surface.
Remove the old chain from the bar.
Lay out the new saw chain in a loop and
straighten any kinks. The cutters should face
in the direction of chain rotation. If they face
backwards, turn the loop over.
Place the chain drive links into the bar groove
as shown.
NOTE:
Make certain of direction of chain.
MAINTENANCE
Fig. 24
CHAIN
TENSIONING
SCREW
BAR MOUNTING
NUTS
Fig. 25
BAR
BAR MOUNTING
NUTS
CHAIN
COVER
MOUNTING
SURFACE
CHAIN
Fig. 26
CHAIN DRIVE LINKS
CUTTERS
CHAIN ROTATION
Summary of Contents for RY405010
Page 91: ...NOTES NOTAS...