6
MAINTENANCE
INSPECTION
Carefully inspect your electronic welding helmet
regularly.
Crack, pitted or scratched filter or cover lenses
reduce vision and seriously impair protection.
These should be replaced immediately to avoid
damage to the eyes.
Inspect the complete helmet frequently and replace
worn or damaged parts immediately.
CLEANING
Clean helmet by wiping with a soft, dry cloth. Clean
cartridge surfaces regularly. Do not use solvent
based cleaners .
Clean sensors and solar cells with methylated spirit
using a clean cloth and wipe dry with a lint-free
cloth.
Never bring the UV filter into contact with water.
Note: The cartridge in the welding helmet is a
sealed unit therefore there are no spare parts
available.
REPLACING THE REAR COVER LENS
Push the 2 tabs outwards, Fig.5, and lift the filter
holder up.
Remove the filter lens.
Slide out the old cover lens.
Pull off the plastic protection film and slide in the
the new cover lens.
Follow the above instructions in reverse order to
refit the filter lens etc.
REPLACING THE FRONT COVER LENS
Push the 2 tabs outwards, Fig.5, and lift the filter
holder up.
Remove the filter lens.
Pull out the old cover lens.
Pull off the plastic protection film and put the new
cover lens back in.
Follow the above instructions in reverse order to
refit the filter lens etc.
WARNING.
Do not use the helmet with
out the cover lenses in place.
REPLACING THE BATTERIES
Push the 2 tabs outwards, Fig.5, and lift the filter
holder up.
Slide the battery compartment down and remove,
Fig.4.
Remove the old battery.
Fit the replacement battery (+) upwards.
Refit the cover and slide up to fully secure.
Follow these instructions to replace the second
battery.
Refit the filter cover and secure in place.
OPERATION
GRIND
To use the grind function turn the on/off
(grind)/shade select switch to grind. When switched
to grind mode the auto darkening filter will not turn
black when detecting any arc light.
Before using the helmet for welding purposes the
switch must changed back to a shade position.
Fig. 5
Summary of Contents for RWH-800A
Page 8: ......
