![background image](http://html1.mh-extra.com/html/ryobi/rts31/rts31_operators-manual_1506617017.webp)
17
ASSEMBLY
TO MOVE THE LEG STAND
See Figure 10.
Holding the leg stand firmly, pull the leg stand toward
you until the leg stand and saw are balanced on the
wheels.
Push the saw to the desired location then either open the
leg stand for immediate saw operation or store the saw
in a dry environment.
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 11.
Lower the blade by turning the height/bevel adjusting
handwheel counterclockwise.
To remove the throat plate, place your index finger in
the hole and lift the front end pulling the throat plate out
toward the front of the saw.
To reinstall the throat plate, first slip the tab into the slot
at the back of the saw and then push down to secure in
place.
TO INSTALL MITER FENCE
See Figure 12.
WARNING:
Make sure the miter fence does not touch the blade guard
before turning on the saw. If anything interfers with the
blade guard, do not use this saw. Failure to heed this
warning can result in serious personal injury.
Loosen the lock knob so the bolt has enough clearance
to slide into the table slot.
Mount the miter fence to the miter table by installing the
locator pin (below the miter fence) into holes “A” or “B”.
At the same time, place the attachment bolt in the slot.
Properly adjust the miter indicator to the scale on the end
of the fence opposite the locator pin.
Retighten the lock knob.
WARNING:
Do not use the miter fence holder if the tabs are not prop-
erly installed in the miter fence slots. Failure to heed this
warning can result in serious personal injury.
Fig. 10
Fig. 11
ATTACHMENT
BOLT
LOCK
KNOB
MITER
FENCE
HOLDER
HOLE “A”
HOLE “B”
TABLE
SLOT
MITER
INDICATOR
MITER
FENCE
LOCATOR
PIN
Fig. 12
SAW TABLE
THROAT
PLATE
MITER FENCE
SLOT