![background image](http://html1.mh-extra.com/html/ryobi/rts31/rts31_operators-manual_1506617015.webp)
15
ASSEMBLY
TO ATTACH THE LEG
See Figure 7.
NOTE: The leg with the leveling foot should be installed on
the front of the saw, right side.
Stand the table saw on end as shown in figure 7.
Slide the leg in the leg stand tubes aligning the holes in
both tubes.
Remove the nut from the end of the carriage bolt then
insert a carriage bolt into the hole (from the outside toward
the inside). Finger tighten using the nut.
Repeat for remaining legs.
NOTE: Once the leg stand is in an upright position (see page
16) and the saw is level, securely tighten the nuts. Place the
saw on level ground and verify the saw’s stability before use.
TO SECURE/LEVEL THE SAW
With the leg stand open and the table saw resting on a flat,
level surface, the saw should not move or rock from side
to side. If the saw rocks from side to side, the leveling foot
needs adjusting until the leg stand is balanced.
Turning clockwise will lower the foot.
Turning counterclockwise will raise the foot.
TO INSTALL THE HANDLE
See Figure 8.
Remove the screw from the handle by holding the
nut securely and turn the screw counter- clockwise to
remove the nut completely.
NOTE: Do not remove the screw from the handle or the
washer from the end of the screw.
Place the nut into the recessed hole on the back of the
height/bevel adjusting handwheel and hold in place.
Slide the handle, screw, and washer into the hole on the
height/bevel adjusting handwheel.
Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
Fig. 8
Fig. 6
Fig. 7
NUT
FLAT
WASHER
SLEEVE
BOLT
WHEEL
FLAT
WASHER
SPACER
NUT
CARRIAGE
BOLT
LEG STAND
TUBE
NUT
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
SCREW
HANDLE
WASHER