Ryobi RTS10, Operator'S Manual

Page: 17 / 116

17 - English
ASSEMBLY
TO INSTALL THE HANDLE
See Figure 9.
 Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE:
Do not remove the screw from the handle.

Place the nylon nut into the recessed hole on the back of
the height/bevel adjusting handwheel and hold in place.

Slide the handle, screw, and washer into the hole on the
height/bevel adjusting handwheel.

Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 10.

Lower the blade by turning the height/bevel adjusting
handwheel counterclockwise.

To remove the throat plate, place your index finger in
the hole and lift the front end pulling the throat plate out
toward the front of the saw.

To reinstall the throat plate, slip the tab into the slot at
the back of the saw and push down to secure in place.
HEIGHT/BEVEL
ADJUSTING HANDWHEEL
Fig. 9
SCREW
NYLON
NUT
WASHER
HANDLE
Fig. 11
THROAT
PLATE
Fig. 10