7
ENGLISH
If necessary, use the plunger provided to push the waste
material down into the feeding chute.
NOTE:
In normal use, do not switch off the garden
shredder until all of the shredded material has cleared
the cutter assembly. If the garden shredder is switched
off too quickly, remaining pieces of material may clog the
blade assembly and stall the motor when the shredder is
switched back on.
CARE AND MAINTENANCE
REVERSING THE BLADE
(see figure 9 figure figure 2 )
. Switch off shredder by pressing the power On/Off
switch to OFF position.
2. Disconnect the shredder from the mains power supply.
3. Unscrew cover using locking knob. (Can refer to the
paragraph: CLEARING OBSTRUCTIONS)
4. Wearing protective glover, using Spanner I (with hex
key) provided unscrew the cutting blade screw A from
the cutting device (see figure )
5. Rotation the cutting blade plate make the screw B can
unscrew by safe blockage hole, and using Spanner
I (with hex key) provided unscrew the cutting blade
screw B from the cutting device (see figure 2)
6. Remove cutting blade, and rotate blade 80 so the
new blade cutting edge is now in use.(see figure 2)
7. Follow the above procedure for the opposite cutting
blade.
8. Assemble the safe blockage, and using spanner II to
tight the screws
9. Ensure all hex screw is fully tightened.
0. Finally return cover, making sure cover is correctly
located and securely re-tighten locking knob.
NOTE:
If cover is not correctly fitted and locking knob not
securely tightened the shredder will not operate.
MAINTENANCE
WARNING!
Before commencing cleaning and maintenance
procedures, make sure the garden shredder is
switched off and disconnected from the mains
supply. Always wear sturdy leather gloves when
cleaning the cutter blades.
. To ensure the best performance from the garden
shredder, it must be kept clean.
2. Always clean the garden shredder immediately after
use.
3. Do not allow material to become dry and hard on any
of the garden shredder surfaces. This will directly
affect the shredding performance.
4. Make sure that the feeder chute and the ejection chute
are kept clean and clear of all waste material.
5. Make sure that all nuts, bolts and screws are tight and
secure.
6. Always have any damaged or worn parts repaired, or
replaced by qualified personnel.
CAUTION
. Do not over tighten the plate adjustment screw and
cut excessive aluminum off of the plate, as this will
reduce the life of your shredder.
2. Have your garden shredder inspected and maintained
by qualified service personnel. Do not attempt to
repair the machine unless you are qualified to do so.
STORAGE
Make sure that the garden shredder has been thoroughly
cleaned before storing it in a clean, dry place out of the
reach of children.
WARRANTY INFORMATION
The manufacturer provides warranty in accordance
with the legislation of the customer’s own country of
residence, starting from the date on which the appliance
is sold to the end user.
The warranty only covers defects in material or
workmanship.
The repairs under warranty may only be carried out by an
authorized service centre. When making a claim under
the warranty, the original bill of purchase (with purchase
date) must be submitted.
The warranty will not apply in cases of:
n
Normal wear and tear
n
Incorrect use, e.g. overloading of the appliance, use
of non-approved accessories
n
Use of force, damage caused by external influences
n
Damage caused by non-observance of the user
manual, e.g. connection to an unsuitable mains supply
or non-compliance with the installation instructions
n
Partially or completely dismantled appliances
