![background image](http://html1.mh-extra.com/html/ryobi/rpw2500wb/rpw2500wb_operators-manual_1506043017.webp)
17
OPERATION
Push the nozzle into the quick-connect collar until it clicks
in place and is secured properly.
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:
Turn off the pressure washer and shut off the water
supply. Point nozzle in a safe direction and pull trigger to
release water pressure.
Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle holder for storage.
WASHING WITH DETERGENT
See Figures 22 - 23.
NOTE: When using detergent, the coiled high pressure
hose can be relocated to the hook-and-loop strap located
behind the handle bar instead of the strap located on the
carrying handle.
Use only detergents designed for pressure washers; house-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage
the pump. Many detergents may require mixing prior to use.
Prepare cleaning solution as instructed on the solution bottle.
Place the injection hose in the bottom of the detergent
bottle/container.
Install the Soap Blaster™ nozzle on the spray wand.
Spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow
detergent to dry on the surface.
For long range detergent application:
With the Soap Blaster™ nozzle installed on the spray wand and
the engine shut off, pull nozzle up until it clicks into place.
For short range detergent application:
With the Soap Blaster™ nozzle installed on the spray wand
and the engine turned off, push the Soap Blaster™ nozzle
down as far as it will go.
DETERGENT
CONTAINER
INJECTION
HOSE
Fig. 22
Fig. 23
LONG
RANGE
SHORT
RANGE
SOAP BLASTER
™
NOZZLE